gertlex (gertlex) wrote in hearingaidhacks,
gertlex
gertlex
hearingaidhacks

Modified DAI pinout idea

I've often desired to be able to have an earbud that you can plug a DAI cable into, and have a functional earbud. 

The main problem with this has been that the DAI cable often is (and should be!) attenuated.  Thus, the earbud would be super quiet if you just attached it in this manner.

It just occurred to me that the middle pin could be connected as unattenuated.  Earbuds would then connect to the ground and center pins, and ignore the attenuated pin.

To illustrate, it is this
http://www.gfern.com/btha/BTE-DAI-Cable.png
but with the V_dd pins connected to the respective left and right connections on the stereo jack.

As far as I can recall, I've never seen this pin actually connected to anything - it's just there for robustness and/or ease of insertion of DAI connector into a hearing aid's boot, I think?  Has anyone ever seen a situation where this would be a bad idea?  Obviously this is only really relevant if you're making a custom DAI connector (does anyone besides me do this?...).

Thanks!
-Gert
Subscribe

  • Roger Pen Hack?

    I have just started to use a Roger Pen and am loving it, I am wanting to use it more often, but would rather have less power output from the pen, or…

  • Connecting Phonak Roger Pen to Bernafon Soundgate 3

    Contrary to Oticon's Streamer the Soundgate 3 does not have a DAI Europort connector, only a stereo jack. This creates a problem with for me.…

  • Captioned Cell Service!

    The FCC has finally approved Innocaption's application to be a relay provider. The hold up was trying to make sure the service wouldn't be used by…

  • Post a new comment

    Error

    default userpic

    Your reply will be screened

    Your IP address will be recorded 

    When you submit the form an invisible reCAPTCHA check will be performed.
    You must follow the Privacy Policy and Google Terms of use.
  • 6 comments